STEP 4 REMOVE HOOD
Remove the hood by removing the four bolts (one on either side above
front tire, and two on either side of hood logo) using 1/2 socket and
wrench.
STEP 6 REMOVE CONSOLE
STEP 5 REMOVE PROP SHAFT COVER
Remove the center console cover by using a pry tool or screw driver,
then remove the console using a 5/16 socket.
If 4WD (if not, skip to step 3) use a 1/2 socket and wrench to remove
the prop shaft cover.
If your unit is a crew, at this time use the same tools to remove the
rear seat console.
1/2” bolt
center console cover
15961 Rev. C
page 3 of 7
carefully pry here