STEP 13 CHOOSE / INSTALL WINCH CONTROLS
Your winch comes with two controller options. A switch that can be
mounted into the dash, or a handheld joystick style controller that be
operated from outside the unit. Choose your preferred controller style
of controller, install and connect to the relay.
Hand held Controller
- Drill a hole through the back of your
glovebox that the is large enough for the 4-pin connector to be
threaded through. Run the connector through and attach to the relay.
The joystick can be stored in the glovebox when not in use.
Dash Mount Controller
- Use
template 1
at left to cut the switch
location out in the dash. The recommended location is shown at
left. To install, the switch must be disassembled and the back of the
switch waterproofed with electrical tape.
STEP 15 INSTALL HOOK AND STRAP
STEP 14 INSTALL WINCH INTO RECEIVER
Use needle nose pliers to remove the cotter pin from the clevis on
the winch hook, and remove the pin from the hook. Ensure the clutch
control knob on the winch is in the ON position, and remove the
rubber band from the spool, being sure to keep tension on the spool
to prevent cable from unraveling from the spool. Carefully turn the
control knob to OFF position and feed just enough cable through the
fairlead to attached the hook. Immediately return the winch control
knob to the ON position, keeping tension on the cable to prevent
unspooling. Install the clevis pin through the hook and cable loop, and
re-install the cotter pin. Use your controller to reel the cable back in
and tight on the winch.
Re-install the seat tray, seat, console, prop shaft cover, and hood.
Install the winch into the receiver and plug in the quick connection.
Use your controller to verify that the motor engages before
progressing with the installation.
15961 Rev. C
page 6 of 7
dash mount controller location
dash mount controller
hand held controller
dash mount switch waterproofed with electrical tape
template 1