American-Lincoln
®
1-19
SC7740
HOPPER SAFETY ARM
The hopper safety arm is located near the right front wheel
well. The safety arms prevents the hopper from dropping
unexpectedly during service/maintenance.
TO ENGAGE SAFETY ARM:
1. Raise hopper.
2. Set parking brake.
3. Lift safety arm to engage the slot on the hopper frame.
4. When work has been completed, replace the safety arm
to the stowed position.
SEAT POSITION ADJUSTMENT
The seat position adjustment lever is located on the front of
the seat to the left. The lever is spring-loaded to the “LOCK”
position. To adjust the seat, push the lever to the “RIGHT”
and move the seat to the desired position. Then release the
lever to “LOCK” the seat into place.
DIRECTIONAL CONTROL PEDAL
The Directional Control Pedal is located on the floor of the
operator’s area. This pedal controls the machine direction.
1.
Apply foot pressure on the right side of the pedal to
move the machine forward.
2.
Increase foot pressure on the right side of the pedal to
increase the forward speed.
3.
Apply foot pressure on the left side of the pedal to move
the machine in reverse.
4.
Increase the pressure on the left side of the pedal to
increase the reverse speed.
The Directional Control Pedal also controls the dynamic braking
of the machine.
1.
To stop the machine, allow the directional control pedal
to return to the neutral (center) position. The pedal will
automatically return to the neutral position when the
foot pedal is released, or when light foot pressure is
applied on the opposite side of the pedal. If the
machine is moving forward, put light foot pressure on
the left side of the pedal. If the machine is moving in
reverse, put light foot pressure on the right side of the
pedal.
OPERATION OF CONTROLS AND GAUGES - Cont.
C2148/0602
C2155/0602
