72
Rev. 5
Operation
Setup Submenu : Net Settings
When
ENTER
is pressed to change the settings protection
password, the current password must be correctly entered before a
new password can be entered.
Using the keypad, type the current 4-digit (maximum) numeric
password and press
ENTER
. The default password is 1234. If an
incorrect password is entered, the Model 430 Programmer beeps
and again prompts for the password. Once the password has been
correctly entered, the user is prompted for the new password.
Using the keypad, type the new 4-digit (maximum) numeric
password and press
ENTER
. The user is then prompted to re-enter
the new password for confirmation.
Using the keypad, again type the new 4-digit (maximum) numeric
password and press
ENTER
. If the second password entry does not
match the first password entry, the Model 430 Programmer beeps
and the user is prompted again to re-enter the new password. The
new password is not accepted until it is confirmed by entering the
same password a second time. If
ESC
is pressed before confirmation
is completed, the display returns to the Settings Password
submenu, and the current password remains unchanged.
3.10.4 Net
Settings
Submenu
Selecting the Net Settings submenu allows all currently assigned network
settings to be
viewed
(but not edited). To
edit
network settings, select the
Net Setup submenu.
+50.00 A — Enter Current Password*
+0.50 Vs
_
+50.00 A — Enter New Password*
+0.50 Vs
_
+50.00 A — Enter New Password Again*
+0.50 Vs
_
Summary of Contents for 05100PS-430-601
