2
AMI
EXCELLENCE IN MAGNETICS AND CRYOGENICS
III. INSTALLATION
The AMI Model 4Q05100PS is designed to operate in an AMI power supply system
consisting of a power supply programmer and a superconducting magnet. The following
paragraphs document the procedures and interconnects necessary to use the Model
4Q05100PS.
WARNING: Before energizing the instrument, the earth ground of the
power receptacle must be verified to be at earth potential and able to
carry the rated current of the power circuit. Using extension cords
should be avoided, however, if one must be used, ensure the ground
conductor is intact and capable of carrying the rated current.
WARNING: In the event that the ground path of the instrument
becomes less than sufficient to carry the rated current of the power
circuit, the instrument should be disconnected from power, labeled as
unsafe, and removed from place of operation.
WARNING: Do not operate this instrument in the presence of
flammable gases. Doing so could result in a life-threatening explosion.
WARNING: Do not modify this instrument in any way. If component
replacement is required, return the instrument to AMI facilities as
described in the Troubleshooting section of this manual.
WARNING: If this instrument is used in a manner not specified in this
manual, the protection provided by the design, manufacture and
documentation of the instrument may be impaired.
A. Carefully remove the Model 4Q05100PS from the shipping container and remove all
packaging material.
NOTE: If there is any shipping damage, save all packaging material
and contact the shipping representative to a file a damage claim. Do not
return the instrument to AMI unless prior authorization has been
received.
B. If the Model 4Q05100PS is to be mounted in a rack:
1. Install horizontal support rails in the rack to support the weight of the Model
4Q05100PS. Securing the front panel alone is not adequate support for the weight
of the unit.
2. Install the Model 4Q05100PS in the 19" wide instrument rack by securing the front
panel to the rail in each of the four corners with mounting hardware supplied by
the cabinet manufacturer.
