INSTALLATIONS
6
MI802 User’s Manual
Installing the Memory
The MI802 board supports two DDR3-1066 memory.
The MI802N board supports one DDR3-800 memory.
Remarks:
D2550 supports SO-DIMM x 2 (w/o ECC), Max. 4GB, Single channel
N2600 supports SO-DIMM x 1 (w/o ECC), Max. 2GB, Single channel
Installing and Removing Memory Modules
To install the DDR3 modules, locate the memory slot on the board and
perform the following steps:
1. Hold the DDR3 module so that the key of the DDR3 module aligned
with that on the memory slot.
2. Gently push the DDR3 module in an upright position until the clips of
the slot close to hold the DDR3 module in place when the DDR3
module touches the bottom of the slot.
3. To remove the DDR3 module, press the clips with both hands.
DDR3 Module
Lock
Lock
Lock
Lock
Summary of Contents for 802
