OPERATING
14
7
Operating WIMS 100
7.1
Turn On the Controller
From the “OFF” state, turn the controller on by pressing
.
The controller needs to stay on in order to operate. Leave it on at all times.
7.2
Read the Walk-in Air Temperature and the Current Time
When on, the LED display will alternate the inside air temperature reading with the
time reading.
(Air Cavity Temperature 38
o
F)
(10:35 PM)
7.3
Read the Door Frame Heater Temperature
WIMS 100 monitors and controls the door frame heater temperature at all times.
To display the door frame heater temperature, press and hold
. The display will indicate the door frame
heater temperature. As an example see the illustration on the right.
When
is released, the controller will switch back to air temperature display.
7.4
Operate the Light Switch
To turn the light on, press
. The green LED, next to the light button, will illuminate indicating ON
status of the light. To turn the light off, press
one more time. The green LED will go off and the red
LED will illuminate indicating OFF status of the light. If the automatic light off feature is enabled, the light will
turn off automatically after the preset time expires.
If a back-to-back light control option was purchased, the light can be switched on and off from the provided
button.
Summary of Contents for Walk-in Monitoring System 100
Page 5: ...CONTROLLER 3 2 Controller ...
Page 18: ...EL DIAGRAM 16 9 Electrical Diagram ...
Page 19: ......
