XM745-V1.0-NR
9
In the case of the move head, which is a 4 channel fixture, you should set the starting address of the
first unit to 1, the second unit to 5 (4 + 1), the third to 9(4 + 5), and so on.
Note:
The modes of DMX 512 data are shown via the display:
DMX OK
NO DMX
1. After switching on, the device will automatically detect whether DMX 512 data is received or not.
If the data is received, the display will show
"A.001"
with the actually set address. If there is no data
received at the DMX-input, the display will flash
"A001"
with the actually set address.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the
device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires
are swap in the input connector.
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in
order to ensure proper transmission on the DMX data link.
8. Control Board
There are four keys on the control panel , which could be used to set the address, turn ON/OFF,
operating the program and reset.
[MENU]
press this key to enter into edit mode. Press this key under the edit mode if you want to
return to previous Mode/Esc. it will exit from edit mode 60 seconds after the last keypress
[UP]
screen will flash when pressing this key in normal mode, the adress value will increasing. Keep
pressing this key, the address value will increase rapidly. it will exit from flash 60 seconds after the
last keypress. Press this key under edit mode, you can choose the function you want from the buttom
up in the Mode/Esc.
[DOWN]
screen will flash when pressing this key in normal mode, the adress value will idecreasing.
Keep pressing this key, the address value will decrease rapidly. it will exit from flash 60 seconds
after the last keypress. Press this key under edit mode, you can choose the function you want from
the top down in the Mode/Esc.
[ENTER]
this key is functionless when in normal mode. Press this key under the edit mode, it will
enter into next Mode/Esc.
Display menu
MODE
<ADDR>
VALU
A001
~AXXX (AXXX)
DMX address setting
SLAV
ON/
OFF
Set as Slave
RDMX
ON
/OFF
Change address via DMX
<RUN>
AUTO
ALON
/MAST
Run Auto program
<DISP>
VALU
D-XX D-00(DXXX)
Display DMX value
