XM745-V1.0-NR
11
—
—DMX address setting, Slave setting
- DMX address setting
With this function, you can adjust the desired DMX-address via the Control Board.
1. Select
“VALU”
by pressing
[UP]
or
[DOWN]
button.
2.
Press
[ENTER]
, adjust the DMX address by pressing
[UP]
or
[DOWN]
button.
3.
Press
[ENTER]
to confirm or pressing
[MENU]
to return to main menu.
- Slave setting
With this function, you can define the device as slave.
1. Select
“SLAV”
by pressing
[UP]
or
[DOWN]
button.
2. Press
[ENTER]
, the display shows
“ON”
or
“OFF”
.
3. Press
[UP]
to select
“ON”
if you wish to enable this function or press [DOWN] to select
“OFF”
if you don’t.
4. Press
[ENTER]
to confirm or press
[MENU]
to return to main menu.
-
DMX address setting via controller
With this function, you can adjust the desired DMX-address via an external controller.
This function can only be activated when the DMX-value of all other channels is set to "0" on the
controller.
Select “EBOC” by pressing [UP] or [DOWN].
Press [ENTER], the display shows “ON” or “OFF”.
Press [UP] to select “ON” if you wish to enable this function or [DOWN] to select “OFF” if you
don’t.
Press
[MENU]
to confirm.
Press [ENTER] in order to return to the main menu.
On the controller, set the DMX-value of channel 1 to "7".
Set the DMX-value of channel 2 to "7"or "8". When set to "7" you can adjust the starting address
between 1 and 255. When set to "8" you can adjust the starting address between 256 and 510.
Set the DMX-value of channel 3 to the desired starting address. If you want to set the starting
address to 57, set channel 1 to "7", channel 2 to "7" and channel 3 to "57". If you want to set the
starting address to 420, set channel 1 to "7", channel 2 to "8" and channel 3 to "164" (256+164=420).
Wait for approx. 20 seconds and the unit will carry out a reset. After that, the new starting address is
set.
- Program Run, Master setting
With the function
"RUN"
, you can run the internal program. You can set the number of steps under
Step. You can edit the individual scenes under Edit.
1. Select
“ALON”
or
“MAST”
by pressing
[UP]
or
[DOWN]
button.
2. Press
[ENTER]
to confirm or Press
[MENU]
to return to the main menu.
