XM745-V1.0-NR
5
Fixed the clamp on the bracket by tighten up the M12 screw on the bracket to the
Ф
13 hole in the
middle of the bracket. Pass the safety rope through the connecting hole under the side panel, hanging
on the fixed bracket or other fixed station, and can also be floor-mounted(or on any other flat surface)
without fixing, remaining steady no matter what the angle of the head. Fully operational in any
mounting position, hanging upside-down, side mounted, or set on a flat level surface, etc. When
clamp mounting; always use and install the supplied safety cable as an added safety measure to
prevent accidental damage in the event of a clamp failure. Be sure this fixture is kept at least 0.1m
away from any flammable materials (decoration etc.).
Notice: this step is quite important to ensure that the fixture will not drop out by the damage
of the clamp.
Layout Drawings: