XM907-V2.2.0-A
24
1
．
Tap <MODE/ESC>button
，
access the main menu
，
Tap the <Up/Down>button until
“
Effect Adjust
”
is displayed. Press ENTER, the display will show
“
Effect Adjust
”
.
2
．
Press <Up/Down>, the display will show
“
Calibration
”
.
3
．
Press< ENTER>, the display will show
“
Calibration
”
.
4
．
The display show
“
Password=XXXX
”
.
5
．
Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
8.7 Users mode set
In this menu, user can select different channels list by different sequence:
For example, after the user enter this manual, if select Auto Program = CH 22, means in this
User’s mode, the “Dimmer” is in Channel 16.
8.7.1 User Mode
With this function, you can create user defined channel orders.
8.7.2 Edit User Mode
With this function, you can adjust the rest user defined channel order.
1
．
Tap <MODE/ESC>button
，
access the main menu
，
Tap the <Up/Down>button until
“
Users
mode set
”
is displayed. Press ENTER, the display will show
“
Edit User Moed
”
.
2
．
The display show
“
User Mode
”
frist channel, Press <Up/Down> the display will show
“
Edit User Mode
”
.
3
．
Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
8.8 Edit program
8.8.1 Select Programs
With this function, you can select the program for the Program Run.
8.8.2 Edit Program
With this function, you can edit the internal programs.
8.8.3 Edit Scenes
With this function, you can edit the scenes of the internal programs.
8.8.4 Rec. Controller
The moving head features an integrated DMX-recorder by which you can transmit the
programmed scenes from your DMX-controller to the moving head. Adjust the desired scene
numbers via the encoder (from – to). When you call up the scenes at your controller, they will
automatically be transmitted to the moving head.
Excursion:
A Master unit can send up to 3 different data groups to the Slave units, i.e. a Master unit can start
3 different Slave units, which run 3 different programs. The Master unit sends the 3 program
parts in a continuous loop.
The Slave unit receives data from the Master unit according to the group which the Slave unit
was assigned to. If e.g. a Slave unit is set to “Slave 1” in the menu “Set to Slave”, the Master unit
sends “Auto Program Part 1” to the Slave unit. If set to “Slave 2”, the Slave unit receives “Auto
Program Part 2”.
To start a Auto Program please proceed as follows:
1. Slave-Setting
•
Select “Function Mode” by turning the encoder.
