17
BRAKE LEVER
❍
Loosen both clamp screws on the Brake Lever and install
it onto the Frame
’
s left handlebar about 4" from the end
with the steel ball end of the Lever pointing left and
forward.
❍
Secure the Brake Lever into position by tightening the
mounting collar screws
.
CAUTION:
Prior to any operation, be sure to adjust the position
of the Brake Lever so that it is readily available to and easily
accessed and operated by the intended rider.
BRAKE CABLE
❍
Locate the Brake Cable & Conduit Assembly.
❍
Seat the barrel end of the Brake Cable into the hole in the
Brake Lever on the left handlebar and rotate the Cable so that
the barrel end fits into the slot in the brake adjuster housing.
❍
Slide the Housing up over the cable until it fits into the
opening in the Brake Lever.
❍
Route the Brake Cable and Housing down the Fork and left of
the Frame toward the brake, using three Conduit Clips to secure
the Cable and Housing to the Fork and frame as you go.
IMPORTANT: Cable and Housing should be routed and secured
to the inner surfaces of the fork and frame. Avoid sharp bends.
Also, make sure that your routing allows the fork to move freely
from side to side without binding or pinching.
SECURE BRAKE CABLE TO BRAKE
❍
Install the cable to the brake actuator arm using the brake
cable barrel connector