A
B
Single Bowl
Double Bowl
Trap
Trap
1
2
Drill a clearance hole
inside the cutout line.
Connect supply lines to
faucet finger tight, and
carefully bend to engage
with the supply stops.
Tighten connections to
faucet for secure seal.
Attach at least four of the support clips to the
underside of the countertop as shown below. The
location of the clips should
be as shown in the sink
diagram. The wood screws
are for use in wood, plywood,
or particle board (drill
appropriate pilot hole).
The inserts supplied are
for use in marble or hard
synthetic material.
Connect drain assembly
hand tight to check align-
ment. It may be necessary
to cut off part of the tailpiece
(area "A") or part of the
horizontal leg of the trap
(area "B").
Secure joint for watertight
assembly.
Mount the faucet and
drain assembly following
the manufacturer's
instructions.
3
Cut fitting holes in the
countertop and remove
the template.
4
Prior to beveling the countertop
edge, be sure that the fitting
escutcheon does not extend
onto the curved portion of the
countertop.
8
7
5
Apply a bead of sealant to
the edge of the sink. Hold the
sink against the under-side of
the countertop and rotate
the clips to hold the sink in
place. Snug the screws to
hold the sink. Attach all the
additional clips.
Sealant
Cutout
Edge
Countertop
41mm
(1-5/8)
Cutout
Support
Clips
Fitting
Escutcheon
Countertop
CAUTION
Countertop
Template
Cutout
Countertop
Template
Cutout
Countertop
Template
Proper fit
Countertop
Cut opening on cut line
of the template.
Note - Formica counter-
top installation only is
illustrated. Contact your
countertop distributor for
the best method of cut-
ting other materials such
as marble, hard syn-
thetics, etc.
Cutout
template
6
Support Clip
NOTE
The following instructions are for
countertop mounted fittings only.
(Silhouette single bowl shown)
END
7 9 0 0 8 8 - 1 0 0 R E V . H
3
