- 3 -
M965798 Rev. 1.0 (3/17)
6
5
INSTALL HANDLES
SERVICE
6a
• Turn hot and cold VALVE STEMS
(1)
to the off position.
• Push ADAPTER
(2)
onto VALVE STEM
(1)
, so the recess in ADAPTER
(2)
is facing toward the back wall.
VIEW “A
”. Install and tighten STEM
SCREW
(3)
to secure ADAPTER
(2)
.
• Align the hole in back of the HANDLE
(4)
with the recess in ADAPTER
(2)
.
Install the HANDLE
(4)
onto ADAPTER
(2)
.
• Tighten SET SCREW
(5)
with 5/64" HEX WRENCH (
6)
supplied.
To change direction of handle rotation, proceed as follows:
• Turn valve to OFF position.
• Loosen handle set screw to remove HANDLE
(2)
from HANDLE ADAPTER
(3)
.
• Loosen the adapter screw
(4)
. Use a flat blade screw driver to remove
SPRING CLIP
(5)
.
• Lift STOP WASHER
(6)
, turn 90˚ and replace.
• Replace SPRING CLIP
(5)
.
• Reinstall HANDLE ASSEMBLY
(2)
and tighten set screw.
• If spout drips, operate handles several times from OFF to ON
position. Do not force - handles turn only 90˚.
HOLE IN BACK
OF HANDLE
RECESS IN BACK
OF ADAPTER
2
1
4
5
6
3
VIEW “A”
VIEW “A”
5/64
"
HEX
WRENCH
90˚
5
6
HOLE IN BACK
OF HANDLE
3
2
1
4
SERVICE — TO REMOVE DIVERTER
•
Turn off the water supplies.
• Turn HANDLE to the off position.
• Remove the HOLDER by threading it counter clockwise.
•
Remove the SLEEVE from DIVERTER by loosening screw.
•
Using 14 mm (9/16") Deep Socket, remove diverter.
DEEP SOCKET
14 mm (9/16")
SCREW
DIVERTER SLEEVE
DIVERTER
HOLDER
