7
INSTALLATION OF SUPPORT BAR
• In this step, you’ll need following parts: [3], [16], [17], [18]
• In this step, you’ll need the following tool: G
[
25
]
[
24
]
[
3
]
[
3
]
[
17
]
[
18
]
[
16
]
Screw
ST4x35
G
View from Inside
Incorrect Fit
Correct Fit
Bracket
Mount
[
17
]
[
3
]
7a
7b
7c
7d
Bracket
Mount
7e
7f
[
10
]
[
10
]
[
10
]
[
6
]
[
6
]
[
6
]
[
9
]
[
9
]
[
9
]
7a.
Remove Bracket Mount from the Wall Bracket [
17
] (illustrated) and install into previous drilled hole from
steps 1d to 1g on the shower wall using one ST4x35 Screw [
16
]. Repeat installation on the opposite side.
7b.
Slide Wall Bracket [
17
] over piece screwed into shower wall, then place Support Bar [
3
] into Wall
Bracket [
17
] on opposite end. Align Support Bars [
3
] 4 clips over the top edges of Fixed Panels A & B.
Repeat installation of Wall Bracket [
17
] on opposite side.
7c.
Align Support Bar [
3
] clips over top edges of Fixed Panels A&B and turn set screws of the Support Bar
clips clockwise using supplied 4mm Allen Key [
25
] to secure Support bar to the Fixed Panels A&B.
7d.
Tighten all set screws of both Wall Brackets [
17
] using supplied 2.5mm Allen Key [
24
].
7e.
Once Support Bar [
3
] is completely installed, observe if there are any gaps between Side Gasket [
6
] and
Door Panel [
9
].
7f.
If any gaps exist along the length of Side Gasket [
6
] and Door Panel [
9
], the Side Gasket [
6
] can be moved
in or out to provide a proper water tight seal (ref. illustration for Correct Fit).
