1
INSTALLING WALL POSTS
1a.
Measure from the outside edge of the base deck 3/4
"
to 1
"
(19 to 25 mm) (ref. main illustration near
bottom) and mark deck of base. Place outside edge of Wall Post [
1
] (slot where glass panel goes) onto
mark on base deck and plumb using Level [
B
]. Tape Wall Post [
1
] to shower wall to temporarily hold in
place. Mark all predrilled holes in Wall Post [
1
] with a pencil [
J
]. Repeat procedure for Wall Post [
1
] on
opposite side.
1b.
If using supplied Wall Anchors [
22
] drill each of the marks on the wall from step 1a using a 6mm drill bit.
If not using Wall Anchors, drill using appropriate size bit for screw being used.
1c.
If using Wall Anchors [
22
], place into each drilled hole.
1d.
Place either left or right Wall Post [
1
] on the wall and screw into place using ST4x35 [
23
] screws. Ensure
Wall Post [
1
] is in correct position (ref illustration).
1e.
Slide the Hole Location Template [
26
] all the way down over left Wall Post [
1
].
NOTE:
the “L” stamped
into the Hole Location Template [
26
] indicating LEFT.
1f.
Mark the hole in the Hole Location Template [
26
] with a pencil [
J
].
1g.
Remove Hole Location Template [
26
] and drill marked location on shower wall with a 6mm Drill Bit [
D
]
if using Wall Anchor [
22
].
1h.
Insert Wall Anchor [
22
] into drilled hole. Tap into place with Hammer [
I
].
• In this step, you’ll need following parts: [1] x2, [22] x8, [23] x8, [26] x1
• In this step, you’ll need the following tools: B, C, D, G, I, J
6mm
L
L
6mm
L
R
1a
≈ 3/4"-1"
19-25 mm
View from
Outside
1a
[
1
]
[
1
]
[
22
]
[
23
]
Round Head Screw ST4x35
[
1
]
[
1
]
[
26
]
[
26
]
[
26
]
[
26
]
[
1
]
1a
1e
1b
J
C
B
I
J
D
D
1c
1d
1f
1g
1h
View from
Outside
[
1
]
Shower
Wall
Shower
Wall
Shower
Wall
Shower
Wall
G
[
22
]
I
B
C
