H98
© 2008 AS America Inc.
EVOLUTION™ OVAL
WHIRLPOOL AND BATHING POOL
HIGH GLOSS
Revised 3/06
NOTES:
BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND, OR PENINSULA TYPE INSTALLATION.
SUMP OF BATH IS SUPPORTED BY INTEGRAL FEET. NO ADDITIONAL SUPPORT REQUIRED. ENCLOSING MATERIAL BY
OTHERS.
■
REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.
OPTIONAL APRON 9266.018 OR 9366.018 AVAILABLE AND MUST BE ORDERED SEPARATELY.
FITTINGS NOT INCLUDED, MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1
These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.
66 x 36 x 19-3/4 In.
(1676 x 914 x 502mm)
96 Lbs. (44 Kg.)
580 Lbs. (263 Kg.)
58 Gal. (219 L)
42 Gal. (159 L)
49 x 26 In. (1245 x 660mm)
62 X 32 In. (1575 x 813mm)
12-3/4 In. (324mm)
35 Lbs./Sq.Ft. (171 Kgs./Sq.m)
GENERAL SPECIFICATIONS FOR 2645V WHIRLPOOL
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
WHIRLPOOL MIN. OPERATING VOL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
WHIRLPOOL ELECTRICAL SPECIFICATIONS
1.4 HP, 9.7 AMPS, 120V.
PUMP
36"
(914mm)
19-3/4"(H)
(502mm)
18-1/4"(C)
(464mm)
C/L OF
DRAIN
15-1/4"(A)
(387mm)
DIMENSIONS OF FIXTURES ARE NOMINAL AND MAY VARY WITHIN THE RANGE
OF TOLERANCES ESTABLISHED BY ANSI STANDARDS Z124.1 AND A112.19.7.
66"
(1676mm)
5-3/8"
(137mm)
6"
(152mm)
36"
(914mm)
8-1/4"
(210mm)
3"
(76mm)
11-1/4"
(286mm)
1-3/4"
(44mm)
18"
(457mm)
CUT OUT IN FLOOR
FOR DRAIN
2645V
Whirlpool shown
GENERAL SPECIFICATIONS FOR 2645V BATHING POOL
66 x 36 x 19-3/4 (1676 x 914 x 502mm)
81 Lbs. (37 Kg.)
565 Lbs. (256 Kg.)
58 Gal. (219 L.)
49 x 26 In. (1245 x 660mm)
62 x 32 In. (1575 x 813mm)
12-3/4 (324mm)
34 Lbs./Sq.Ft. (167 Kgs./Sq.m)
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
