American Standard FB104, Installation And User Manual

WASH 

BIDET 

STOP  

Turn the lever clockwise from the horizontal position.
Nozzle for WASH moves forward and start the function.
The water volume changes with the turning of lever.

Turn the lever anticlockwise from the horizontal position.
Nozzle for BIDET moves forward and start the function.
The water volume changes with the turning of lever.

During wash or bidet status, rotate the knob to horizontal 

and stop douche. 
Nozzle moves back to original position.

The water volume changes with the turning of lever until 

totally shut off.

1. Close the water valve and detach water pipe from

   the water tank. Connect the t-shaped connector to 

   the water tank. Make sure that rubber packing is 

   inserted in between.

3. Press the filter and washer at the two ends of 

water hose into the screw tube, then connect the 

main body and T-shaped connector with water hose.

Washer

Filter

Connecting water hose

Prohibition

1.Do not lift the product with the seat cover and seat open.

2.Cannot use with the hot water which temperature is higher

 than 40 ° C .

This may cause a mechanical  trouble.

4. Open the water valve to check if there is any 

    leakage.

1

3

2

 Note: Please remove the regulator cover and regulate o-ring under the following conditions:

Caution: Must use the regulator cover and regulate o-ring when the water pressure 

is bigger than 0.1MPa.

3

、

Insert the regulator component into the inlet pipe.

2

、

Remove the regulator cover and regulate o-ring except the sealing o-ring.

1

、

Take out the regulator with pliers and other tools.

b.When the nozzle cannot work normally and water is low.

a

．

When the water dynamic pressure is lower than 0.05MPa, especially using 

the family tank. 

2.Connect the water pipe to the t-shaped connector.

Regulator

Regulator 

cover

Regulate 

o-ring

Sealing 

o-ring