DRAIN CONNECTION AND SYSTEM TEST
POST INSTALLATION CLEAN-UP
Using recommended drain assembly, connect whirlpool drain to waste line in accordance with the drain
assembly instructions.Tighten all drain joints securely. Check the pump couplings and make sure they are
hand-tight. Clean the whirlpool and fill withwater to a point 2"" above the top of the highest jet. Recheck the
pump couplings and make certain that they are not leaking. (Although the pump couplings are factory tightened
and inspected, some loosening may have occurred during transit.) Make sure the whirlpool is connected to
the electrical supply and turn the whirlpool on. Check for leaks around all piping connections while the whirlpool
is running.
Remove all construction debris from bath. Tile grout can be removed with a wooden popsicle stick or tongue
depressor. Do not use wire brushes or any other metal implement on bath surface. Post installation clean-up
generally can be completed using warm water and liquid dishwashing detergent. Stubborn dirt or stains may
be removed using granular Spic and Span
®
mixed with water. Painter’s naphtha can be used to remove excess
adhesives and/or wet oil-base paint.
AFTERCARE AND CLEANING
The high gloss surface is resistant to impact and chemicals and will retain its lasting luster with proper care
and maintenance.
Always fill the tub with temperate water. Excessively hot water may cause surface damage.
Clean after use with a mild liquid household detergent cleaner. Do not use Lestoil
®
, Lysol
®
Disinfectant (spray or
concentrate), or Lysol Basin, Tub and Tile Cleaner, Windex, Mr. Clean
®
, Dow
®
Disinfectant Bathroom Cleaner, or
cleaning products in aerosol cans.For occasional, more concentrated cleaning efforts Lysol Non-Abrasive Bath-
room Cleaner works extremely well.
HARSH CHEMICALS SHOULD NEVER BE USED ON ACRYLIC SURFACES.
Do not use wire brushes, knives or sharp objects to remove stains, cigarette tar deposits,or other
surface blemishes.
Abrasive cleaners or powders must not be used, since they will dull the surface. If the glossy surface looses
its sheen, dulled areas can be restored by rubbing with a white “automotive type” polishing compound and
waxing with a “liquid wax.”
Do not wax areas where you walk or stand.
Do not allow nail polish remover, acetone, dry cleaning fluid, paint remover or other solvents to come into
contact with the surface.
Clean the surrounding surface immediately after using caustic drain cleaners.
Burning cigarettes will damage the surface.
Should damage to the fixture occur, repairs can be made quickly and easily. Your distributor or builder can
provide details.
Do not permit drain cleaner to enter the circulation system.
CIRCULATION SYSTEM CLEANING-PURGING PROCEDURES
STEP 1.
Once every month purge and clean the circulating system. Fill whirlpool with warm water and
add two teaspoons of dishwasher detergent and one-half cup of house hold bleach.
STEP 2.
Activate whirlpool system in accordance with operating instructions or two minutes.
STEP 3.
Drain and refill whirlpool with cool water and circulate for additional five minutes.
STEP 4.
Drain whirlpool completely.
