7
M965985 (11/18)
MAINTENANCE
A
HAND WASH SENSOR OPERATION;
Fig. 7
REMOVE PROTECTIVE FILM FROM SENSOR EYE WHEN
INSTALLATION IS COMPLETE.
When the Sensor detects a user, the water immediately starts
to flow. Water flow will stop 1.5 seconds after user is out of
sensor range. This Comfort delay allows the user to comfort-
ably move their hands without the water turning off.
As a precaution, a Safety Timer will turn off the water after the
sensor has been blocked for 59 seconds. The water will stay
off until the
blockage is removed from the detection zone.
The Comfort and Safety time settings can be adjusted using
the
Optional Remote Control (605XRCT).
B
REPLACE BATTERY; Fig. 8, 9
1. Remove 3 COVER SCREWS (1) and lift COVER (15) off.
2. Disconnect SENSOR CABLES (6) and (7) from the
BATTERY and SOLENOID VALVE.
(Fig. 9)
3. Push BATTERY (17) forward and Pull it out. (Fig. 8)
4. Replace the new battery with the same placement.
(Insert terminal side first)
C
CHANGE SENSOR RANGE;
Fig. 8, 9
1. Remove 3 COVER SCREWS (1).
2. Remove the COVER (15).
3. Disconnect the BLACK POWER SUPPLY CONNECTOR (7)
and reconnect.
Fig. 9.
4. While the SENSOR CONTROL LED (9) is blinking slowly,
place your hand 1 - 2 in. (25.4-50.8mm) in front of the sensor.
5. When the LED stops blinking and stays “ON”, move your hand
to the desired position and hold in place until the LED begins
to blink again.
6. Once the SENSOR CONTROL LED (9) begins to blink
again,
remove your hand from the detection zone. When the flashing
stops, the detection distance is set.
7. Reassemble the COVER (15) and secure it with COVER
SCREWS
(1).
15
16
2
1
4
9
14
7
Fig. 8
Fig. 9
6
12
17
Fig. 4
DETECTION
ZONE
PROTECTIVE FILM
IMPORTANT: Do not
use sealent on threads
1
2
3
COLD
HOT
(3) INLINE
FILTER
Fig. 6
5
4
Fig. 5
1
9
8
7
5
3
1
Fig. 7
