INSTALLATION INSTRUCTIONS
The variety of installations possible for this bath may require installation procedures other than those shown. Ensure roughing-
in dimensions are proper, plumb and square. Provision must be made in all installations to attach bath to floor. Slots
are provided in each foot for fastening purposes. Use appropriate fastening hardware according to your flooring
construction.
NOTE: Water supplies and bath drain should be installed prior to securing bath to floor.
1. Remove bath from packaging, do not remove protective foam cover from bath.
2. Carefully turn bath upside down and set on floor. Foam will protect finish of bath as assembly is completed.
3. Unpack feet to be mounted to bath, each foot is individually marked on the back with the numbers 1, 2, 3, or 4.
4. Using the fasteners provided with the feet, mount feet onto bath in the appropriate position, as shown in Fig. 2 below.
Three holes are provided in each leg. Feet may be adjusted as necessary to provide best fit, and smallest gap between
bath and foot. When attaching bolts, use two of the closest holes that provide the best fit. Some space between bath and
feet is normal due in part to the manufacturing tolerances of this product.
5. After foot mounting is complete, carefully upright bath to normal position. Move bath into desired position. (See rough-in
drawing for dimensions of bath filler supplies from wall.)
6. After bath is in position, mark on floor, through the slot in each foot, for rigid mounting bath to floor.
7. Move bath to a safe location.
8. CAUTION: bath must be secured to floor. Select one of the following methods for anchoring: If hole was drilled
through floor, toggle bolts should be used to secure bath. If floor is concrete, use masonry anchors and appropriate bolts.
If floor is solid wood, 5/16" lag bolts may be used. Drill flooring material with appropriate drill bit.
752515-100 Rev. D
(2)
DRAIN CONNECTION ASSEMBLY AND LEAK TEST
Follow instructions provided with drain for proper assembly procedure. Provide a 1-3/4" dia. hole through floor in location
specified in Fig. 1, connect bath drain to waste line. Tighten all drain joints securely. Clean the bath and fill with water and
check for leaks around all drain connections.
POST INSTALLATION CLEAN-UP
Remove all construction debris from bath. Do not use wire brushes or any other metal implement on bath surface.
Post installation clean-up generally can be completed using warm water and liquid dishwashing detergent. Stubborn dirt or
stains may be removed using granular Spic and Span® mixed with water.
Painter's naphtha can be used to remove excess adhesives and/or wet oil-base paint.
HARSH CHEMICALS SHOULD NEVER BE USED ON ACRYLIC SURFACES.
Abrasive cleaners must not be used since they will scratch and dull the surface. Dulled areas can be restored by rubbing with
a white automotive-type polishing compound and waxing with a liquid wax.
If a scratch should occur in the backing material, it is easily repaired by using paste or liquid shoe polish followed by buffing.
#1
Fig. 2
Front
of Bath
#3
#4
#2
Foot Ledge
Floor
attachment
slot
Foot
BATH
Frame
