RONDO™ WHIRLPOOL
HIGH GLOSS ACRYLIC
© 2003 American Standard Inc.
NOTES:
BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND OR
PENINSULA TYPE INSTALLATION. SUPPORT OF BATH BY INTEGRAL FEET. NO ADDITIONAL
SUPPORT REQUIRED. SUPPORT AND ENCLOSING MATERIAL BY OTHERS.
REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL
INFORMATION.
CUTOUT TEMPLATE PROVIDED IN SHIPPING BOX, MAY BE REQUESTED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
F I T T I N G S A N D T W I S T G R A B B A R N O . 7 5 0 5 6 5 - 0 0 0 N O T I N C L U D E D , M U S T B E O R D E R E D
SEPARATELY.
IF INSTALLING A DECK-MOUNTED FITTING, BEFORE DRILLING ANY HOLES: CHECK FOR
I N T E R F E R E N C E W I T H C I R C U L A T I N G S Y S T E M P I P I N G , D R A I N O V E R F L O W , A N D A P R O N
INSTALLATION. MOUNTING HOLES DRILLED BY INSTALLER.
ON SYSTEM II: CONTROL MODULE TO BE MOUNTED BEHIND ACCESS PANEL, A MINIMUM OF
152mm (6) ABOVE ROUGH FLOOR.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances
established by ANSI Standard Z124.1
These measurements are subject to change or cancellation. No responsibility is assumed for use of
superseded or voided leaflet.
●
●
■
1816mm
(71-1/2)
546mm
(21-1/2)
ROUGH
FLOOR
495mm
(19-1/2)
908mm
(35-3/4)
165mm
(6-1/2)
76mm
(3)
ON/OFF
SWITCH
PUMP
C/L OF DRAIN
229 X 305mm
(9 X 12)
CUTOUT
1067mm
(42)
267mm
(10-1/2)
PROVIDE ACCESS
TO PUMP FOR SERVICE
ON ALL INSTALLATIONS
51mm
(2)
OUTLINE OF
CUTOUT
95mm
(3-3/4)
83mm
(3-1/4)
38mm
(1-1/2)
C/L OF
OVERFLOW
38 mm (1-1/2)
TAILPIECE
LEVELING STRINGER
NOT FOR SUPPORT
●
RECOMMENDED FITTING
LOCATION 64 X 279mm
(2-1/2 X 11)
▲
■
INTEGRAL
FEET
SAFE-T-HEATER
REMOVABLE BLANK
GENERAL SPECIFICATIONS FOR 7242 WHIRLPOOL
WHIRLPOOL ELECTRICAL SPECIFICATIONS
SYSTEM II PUMP
71-1/2 x 42 x 21-1/2 In (1816 x 1067 x 546mm)
94 Lbs.(43 Kg.)
818 Lbs.(371 Kg.)
87 Gal. (330 L)
67 Gal. (254 L)
45 x 25 In. (1143 x 635mm)
60 x 30 In. (1524 x 762mm)
14-7/8 In (378mm)
39 Lbs./Sq.Ft. (191 Kgs./Sq.m)
30.3
58.7
2.1 HP, 15.6 AMPS,120.
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
WHIRLPOOL MIN. OPERATING VOL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT
3
)
