If clock was not preconfigured at American Time as recommended, please reference the
Installation & Operation Manual.
5
Set up the Wi-Fi clock
1.
Apply power to the clock by inserting the barrel plug
(B)
of the battery pack into the left
side of the Wi-Fi module where the power connection is located.
• Verify the LED
(C)
:
– Flashes red when power is applied to the clock
– Turns solid green within 60 seconds
– Solid orange indicates a time server connection failure
– Solid red indicates a failed Wi-Fi connection
• Verify the clock hands begin to spin rapidly within three minutes after applying power.
• Verify the correct time on the clock within 10 minutes of applying power.
If any of these steps do not occur, reference the Wi-Fi Clock Installation & Operation Manual.
Hang your clocks
1.
Place the clock on the wall using the keyhole hanger on the back of the clock or the
optional security bracket (sold separately).
6
B
Battery
pack power
input
C
LED
A
Red gear
locking pin
Security
Bracket
Keyhole
Hanger
INST-WIFI-ANA Rev 3
AC
DC
To
wiring
box
4
Verify clock hand placement
1.
Verify the clock hands are set at 12:00 by the factory (if not, stop and call 800-328-8996)
Note:
It is normal for the minute hand to shift ±
1
⁄
2
minute.
2.
Remove the red gear locking pin
(A)
from the movement.
