861 Taylor Rd., Suite “I”
Columbus, Ohio 43230
www.ame-medical.com
Phone: 1-866-633-2337
Fax: 1-614-237-1177
customerservice@ame-medical.com
ASSEMBLY INSTRUCTIONS:
STEP 1
The bottomm portion of the assembled bed will be in the low position. Plug bed in.
STEP 2
Insert hand control. When inserting hand control, pins of junction box must match up with plug of
hand wand.
STEP 3
Attach saddle section to the frame, inserting the four bolts from the saddle section into the four
holes on the frame. Secure saddle section by tightening bolts firmly.
STEP 4
Take head section
(A)
and attach saddle section
(B)
. Match up the hinges for the pins. Insert slide
bolts and secure by tapping them firmly into place. Secure slide bolts with Clevis pins by taping
them in firmly.
STEP 5
Attach the thigh section
(C)
to the saddle section
(D)
using the same procedure in Step 4. Repeat
procedure for foot section.
STEP 6
Clevis pin in actuator tube to be attached to forks of Head and Thigh.
STEP 7
Secure foot lift bars on the sides to the frame of the bed with 1/4 inch bolts and secure with
locking nuts. Do not over thighten the bolts.
STEP 8
Raise foot to high positin and place mattress guard at foot end using a ratchet and 7/16 socket.
STEP 9
Lower foot section and take foot board
(E)
and place into bracket holders. Do the same for the
head board
(F)
. The head board is wider than the foot board. Make sure the bracket holding tubes
do not face the bed when attaching the head board.
