Americana Outdoors, Inc.
10
Navajo Installation Guide
OPTIONAL
-
Cupola Assembly
Cupola
(N)
is sent fully assembled.
Center and square cupola
(N)
on rafters
(B)
over tie
block
(D)
. Attach the cupola to the rafters using (3)
#12 x
1
-
1/4”
screws
(BB)
through the pre
-
drilled
holes in the mounting plate at each corner of the
cupola.
If you ordered a louvered cupola and the louvers
are not already installed, remove the louver screw
cover cap and attach the louver to the cupola frame
using #12 x
1
-
1/4”
screws
(BB)
at each corner of
the louver. Then re
-
attach the screw cover cap.
Continue with Step 5 on page 9
Set the straight end of ridge cap
(E)
against the edge of the cupola
mounting plate. Once ridge cap
(E)
is attached to rafter
(B)
, position
ridge cap flashing
(P)
on top of the ridge cap and fit against cupola
(N)
.
Attach ridge cap flashing
(P)
to ridge cap
(E)
using #8 x
1/2”
screws
(AA)
.
Continue until Step 6 on page 15
The longest roof panels
(G)
attach to the bottom flange of cupola
(N)
. First, fit cupola flashing
(O)
over
the top end of roof panels
(G)
, then attach as shown in Step 7. Once all roof panels
(G)
are installed,
attach cupola flashing
(O)
to the roof panels using #8 x
1/2”
screws
(AA)
at
8”
on center.
C1
C3
C2
