Blower On/Off
1st Press:
The blower starts at 50%
2nd Press:
The blower stops.
Blower System Speed
1st Press:
Press and hold to increase the blower speed, release
pressure at the desired speed.
2nd Press:
Press and hold to decrease the blower speed, release
pressure at the desired speed.
Blower Wave Mode
1st Press:
Wave - Speed will vary gradually from maximum to
minimum.
2nd Press:
Pulse - Speed will go directly to minimum and then
straight back to maximum.
3rd Press:
Returns to maximum speed.
Pump On/Off
The pump starts
The pump stops
Chromotherapy
1st Press:
Auxiliary equipment ON > White
2nd Press:
Slow rainbow cycle
3rd Press:
Fast rainbow cycle
4th Press:
Turquoise, Blue, Magenta, Red, Orange, Yellow, Green
Return to slow rainbow cycle
Press and Hold 1 sec.:
Auxiliary equipment OFF
Water Level Sensor
The system will turn OFF if the water level falls below the water level sensor
while pump is on.
If water falls below water level sensor while blower is on, an automatic purge
will initiate in thirty minutes to dry the air channels.
Automatic Purge
Thirty minutes after the water falls below the water level sensor the blower
will start again for a one-minute purge cycle allowing piping to thoroughly
dry.
Each system will automatically stop after 20 minutes.
CO M B O S E R I E S + L I G H T
operating instructions
Always use dedicated outlets for each power supply.**
IMPORTANT:
Keep these instructions with the Americh Installation Instructions. These operating instructions are for units with systems. All installation, warnings,
warranties, and other such information can be found in the Americh Installation Instructions. Go to www.americh.com for additional copies.
l i s t e d by
in compliance with
ANSI Z124.1 - 1995
ANSI A112.19.7 - 1987
ANSI A112.19.8 - 1987
City of Los Angeles
M980036 and M820132
Always check www.americh.com for the most updated installation instructions.
©10/17
**Note: Blower hose for AirBath Systems is shipped loose:
1) Remove red caps from blower and check valve.
2) Attached grey hose to blower and check valve.
3) Tighten clamp around each end.
Manufacturer recommends the use of Jet Fresh® or a similar system cleaning solution to maintain your whirlpool or Airbath® System.
