TURO™ 6036 RH
Jet
Suction
Rotary Jet
ON/OFF Control
Grab Bar
Access Panel
(See Installation Tips)
Light
BATHING SYSTEMS
LEGEND
( ) Standard on Platinum Series
Mfg ID Label
Builder Series
Luxury Series
Platinum Series
Combination
(pump and blower location only)
Airbath System II
Pump
Blower
Airbath System V
OPTIONAL ACCESSORIES
ELECTRICAL REQUIREMENTS
Americh recommends one 20 amp ground fault circuit
interrupter (GFCI) for each power supply provided
with the bathtub.
INSTALLATION TIPS
Airbath System V
1. Install according to Owner’s Manual and local codes.
2. Always consult your local plumber for recommendations as installations will vary.
3. Any tub with a single system requires an access panel with minimum dimensions of
16” high x 20” wide.
4. Bathtubs with a combination of systems will require an access panel with minimum
dimensions of 16” high by 28” wide. Tubs with multiple systems may require two
separate access panels depending on the tub configuration and equipment.
5. The combination of multiple systems and options may require components to
stick out and/or be remotely installed in the field. Check with factory before
ordering.
6. Hot water supply should be 65%-75% of tub capacity or greater.
All bathtub dimensions are ± 1/2”
Always check our website for the most updated specifications:
Americh.com
Last Update 11/20/20
• ANEX (Americh Nanobubble Experience)
• Chromatherapy
• Grab Bars: 9” - 14” - 16”
• High Density Insulation
• iBath Sound System
• Inline Heater (whirlpool only)
• Jets: Additional or Rotary
• Ozone System (whirlpool and/or Airbath only)
• Pillows: 12” - Angle
• Remote Control Upgrade (select series only)
• Serenity Soak (tub only)
• Syllent Pump with Heated Air
• TCS - Thermal Comfort System (cannot use with VSM)
• Trim Kit Upgrade
• VSM - Vibro Sonic Massage (cannot use with TCS)
• Waste & Overflow Upgrades
- Cable Drive Waste & Overflow
- PVC Waste & Overflow
- Linear Waste & Overflow
