AmeriGlide RUBEX, Installation Manual

11 // 

16

Rubex Stair Lift Install Manual  |  www.Ameriglide.com  |  866-378-6648

11819    P/N: 16169   Rev D

INSTALLING PLASTIC CHAIN AND TRAVELING POWER CABLE

Step 1:

 Lay cable and chain in track. It will 

extend a little more than half way down the 

track.

Step 2:

 Take one side of the traveling cable 

and truck into the bottom channel in the middle 

of the track.

NOTE: The power cable will face in toward 

the metal channel.

Step 3:

 Feed the other side of the cable into 

the channel on the opposite side.

Note: Check every chain link. If unsnapped, 

the chain will not bend correctly.

Step 4:

 After laying the trailing cable and guide chain into the track 

channel, pull down on the cable to make sure there is no slack and it is 

straight under the left channel tight against the side.

Step :

 While holding the cable tight in place, use a 

1

/ 

4

"

  driver to run 

the self drilling screw into the track utilizing one of the two holes in the 

guide chain mounting bracket. Two holes are provided in the mounting 

bracket in the event that one of the holes would happen to be directly 

over a splice between two pieces of track.