AmeriGlide RUBEX, Installation Manual

14 // 

16

Rubex Stair Lift Install Manual  |  www.Ameriglide.com  |  866-378-6648

11819    P/N: 16169   Rev D

INSTALLING THE UPPER LIMIT CAM

STEP 1:

 To install the upper limit cam, run the lift down about 

1 foot by using the control on the armrest.

STEP 2:

 Locate the upper limit cam and move to the top of 

the track - position it approximately ½

"

 from top track cover 

and tighten into place.

STEP 3:

 Final Limit Switch Actuator In the event that the 

lift over travels or is moved up past the normal upper stop 

position, the lift will push the final limit actuator up into the 

final limit switch disabling the unit. In order to return the lift 

to operation, you must manually hand crank the lift down the track a few inches, and then 

slide the final limit actuator down approximately one inch by tapping on it.

INSTALLING THE CALL CONTROLS

STEP 1:

 Finish routing the call control wire into the upper 

track channel on the wall side of the track. Plug into one of 

the two call control connectors.

STEP 2:

 Plug in the upper call control box to a call control 

connector.

STEP 3:

 Plug in the lower call control box to the call 

control connector at the bottom of the track.

NOTE: Call controls can be mounted to the
floor so they can be operated by your foot,

or placed on the wall and operated by hand.
Run the unit down to a few inches past the

lowest track splice.

Lower call control box

Upper call control box