Rubex Stair Lift Install Manual | www.Ameriglide.com | 866-378-6648
4 //
16
11819 P/N: 16169 Rev D
BEFORE YOU START
Pre-Installation Checklist
□ Is there any visible damage to the packaging? If so, immediately contact the freight
carrier and report the damage.
□ The side of the stairs on which the unit and track will be installed are marked on
the chassis and seat boxes. Verify that you have received the correct hand unit (as
looking up from the bottom of the stairs).
□ Is a properly grounded 110 VOLT, 15 AMP (standard outlet), available within 10
'
of
the top of the track?
□ Have you “pulled” the necessary permits in your area for installation?
□ Are your stairs made of wood? If not, special mounting hardware will be required.
Contact your dealer for assistance.
□ The track will extend 6
"
beyond the top step. Is there a door or other obstruction at
the top that will interfere? If so, contact your dealer for assistance.
□ If after reading the instructions, you don’t feel capable or comfortable with
completing the stair lift installation, please contact your dealer for assistance
in finding a qualified installer in your area.
ETL Requirements
This ETL listed stair lift must meet
the latest ASME A18.1 standards
for the ETL listing to be valid. You
must comply with the following
clauses at the installation site.
ASME Clause 4.1.1
*
Lifts shall be installed so that means of egress is
maintained as required by the authority having
jurisdiction.
ASME Clause 4.1.2
*
The structure on which the equipment is
installed shall be capable of safely supporting
the loads imposed.
ASME Clause 4.7.2
Limitation of Angle. No lift shall be installed
to operate on a great-er incline than 45° as
measured on the mean.
*
Applicable to stair lifts installed in locations other than in or at a private residence.
Summary of Contents for RUBEX
Page 16: ...11819 P N 16169 Rev D ...
