©2010 (rev 12/09)
A m e r i s t e p ® I n c . 9 0 1 T a c o m a C t . • P . O . B o x 1 8 9 • C l i o , M I 4 8 4 2 0 ( 8 1 0 ) 6 8 6 - 4 0 3 5 w w w . a m e r i s t e p . c o m
Instruction and Safety Manual
B e s u r e t o f o l l o w t h e s e g u i d e l i n e s f o r u s i n g y o u r P r o d u c t .
R E A D A N D U N D E R S T A N D A L L I N S T R U C T I O N S a n d W A R N I N G S F I R S T
Any questions or confusion regarding use of this product
contact our Customer Service Department.
PLEASE NOTE:
Images used are for demonstration purposes only and may not depict the actual product.
THE
LOW-PRO SERIES
CHAIR BLIND
Models #2402 & #2403
Step 1:
Find two lock buckles attaching spring steel to blind.
Step 2:
Using EXTREME CAUTION release each
ladder lock buckle SLOWLY; freeing spring steel
arms from blind. Layout blind as shown. Locate
two hook-n-loop tabs are sewn inside.
Step 3:
Open Chair.
Step 4:
Place opened Blind behind chair.
A
B
Step 6:
Bring Arm bar up to Chair arm. Depress button and slide into chair arm. Repeat on the
other side so they both look like figure 6a. You should hear the spring button “click” into place
and see the release button in hole on outer side of armrest.
fig 6a
fig 6
Step 7:
Cover Arms with Armrest pads.
Step 8:
Your Chair Blind should look like this.
Step 9:
Sit in Chair. Grab Blind and bring forward
over your head until it fully covers you.
Step 5:
Locate the two hook-n-loop strips on blind.
Attach hook-n-loop strips to
A
and
B
on chair as indicated.
Hook-n-Loop
Tabs
