MAINTENANCE
LAB STORAGE TANKS
21
98-0123 Rev E
Carefully insert the lamp
into the reactor vessel
Attach the connector to
the lamp and note that
the connector will only
allow correct installation in
one position.
Ensure that the connector
is fully seated onto the UV
lamp.
Push the lamp connector
against lamp connector
base together until an
audible click is heard. Re-
pressurize the system to
check for leaks.
Close the sample port on
the filter housing and turn
the water source back on.
Replace the line cord into
the power source.
Hold down the timer reset
button and reapply power
to the controller until you
see rSET, then release
timer reset button. A 5
second delay will occur
until you hear an audible
tone and LED display will
read once again 365
Disinfect per the
instructions in section 6.
Summary of Contents for 00HC-4090
