3
3.0 INSTALLATION
These are basic installation guidelines for the Bicarb Manual Mix and Dispensing System.
CAUTION:
Local plumbing and electrical codes must be observed
.
3.1
INSTALLATION REQUIREMENTS
The following requirements must be satisfied to insure proper installation and operation of
the Bicarb Manual Mix and Dispensing System.
1. Locate the Bicarb System on a level floor.
2. Locate the system as close as possible to a floor drain (to facilitate draining of the system).
3. Connect the purified water supply to the inlet hose located at the top of the pump header,
using the ½” inside diameter medical grade hose provided.
4. Plug the Bicarb Pump Control into a 120 V, 20 AMP, and dedicated, single-phase
electrical service.