User Guide
2 - 2
Signal Processor
LMG MkII
2.1 Installing the Processor in a Panel
1) Refer to Fig. 2-1. Choose an area of your mounting panel of sufficient
size to contain the processor.
2) Carefully cut a rectangular area out of the panel 184 mm / 7.2 in wide,
by 137 mm / 5.4 in high.
3) Refer to Fig. 2-3. Unscrew the four retaining screws on the rear of the
processor and slide out the two clamp bars.
4) From the viewing side, insert the processor in the mounting panel.
5) From the rear, re-insert the clamp bars into their channels and push
them up to touch the mounting panel.
6) Insert and tighten the retaining screws until the mounting panel is
firmly gripped between the processor front panel and the clamp bar.
CAUTION
Do not overtighten the screws as this will deform the clamp bar.
Clamp bar
Retaining screw
Mounting panel
Viewing side
Fig. 2-2 Mounting the processor in a panel
Summary of Contents for LMG MkII
