26
2017-08-11
125614
04
5.
Select ASCII setup from File/Properties/Settings and mark
these choices:
Echo typed characters locally
Wrap lines that exceed terminal width
6.
Select Ok
7.
To see if the port works enter *IDN?. This command will
return information on the unit.
6.2
Units
6.2.1
Temperature units
CEL = °C
KEL = K
FAR = °F
6.2.2
Electrical units
V = volts
OHMS = ohms
A = amps
Hz = Hertz
MV = 10
-3
V
KOHMS = 10
3
OHMS
6.3
Commands
6.3.1
*CLS
SCPI standard command (Clear Status).
Clears the ESE, ESR, SRE and STB registers, i.e. set them to 0.
6.3.2
*ESE <reg val>
SCPI standard command (standard Event Status Enable).
