125614 04
2017-08-11
39
9.0 Adjusting the multi-scanner
9.1
Adjusting and calibrating the instrument
You are advised to return the instrument to AMETEK Denmark A/S or
an accredited laboratory at least once a year for calibration and
adjustment.
•
Alternatively, you can calibrate/adjust the instrument yourself
using the AMETRIM Adjust and Calibration Software.
9.2 Introduction to AMETRIM Software
This software is supplied on the JOFRACAL CD-ROM. It can be run
directly from this CD-ROM and requires no special installation.
It is possible to make a disk containing the AMETRIM software. From
this disk AMETRIM can be installed on the hard disk of the computer,
but the disk has to be in the disk drive when running the software.
To use the software, you need:
PC hardware requirements
•
IBM compatible PC with 486 or higher processor (Pentium
TM
200
MHz recommended).
•
32 MB of RAM (64 MB recommended).
•
40 MB available hard-disk space.
•
Standard VGA monitor (800 x 600, 256 colours), (1024 x 768
recommended).
•
CD-ROM drive.
•
One vacant RS 232 Serial Port.
PC software requirements
•
Microsoft Windows
®
98, Microsoft Windows
®
NT 4.0, Microsoft
Windows
®
2000, Microsoft Windows
®
ME, Microsoft Windows
®
XP.
•
System font: MS Sans Serif and Arial.