44
2017-08-11
125614
04
The number and type of electrical inputs to be checked is user-
definable. You can also define if you want to check the inputs by just
measuring them, adjust and calibrate or to measure, adjust and then
calibrate the electrical inputs.
Cold Junction compensation requires a special setup, using a
calibrated thermocouple and temperature source, for example an ice
bath. This and the measurement principles are shown briefly below:
If at any point you do not wish to continue, click Stop. The software
exits this option and returns to the Main Menu.
In AMETRIM main menu, click Run calibration/adjustment.
Container with ice
0°C reference
Principle sketch