Page 15 of 15
503158 ISSUE 3
EDCR21694
4.1.3 Laser Beam Control
The laser Beam can be switched off. Allowing the lasers to measure points that are close together where beam interference may cause a
problem. In the beam off mode the laser head remains powered which keeps the laser operating at full performance so that readings can
be taken quickly after turning the beam back on.
5
ORBIT AND ORBIT ACS INTERFACES
The LTX comes connected to either an Orbit module or an Orbit ACS module.
All of the laser functions can be set either using the Orbit Interface controllers such as the USB Interface Module and the Orbit Support
Pack for Windows. Orbit commands to set up the laser can be found in the Orbit Software Manual available on the Solartron Metrology
Web Site.
Instructions for using the Orbit ACS version can be found in the Orbit ACS manual available on the Solartron Metrology Web Site. The
Laser can be set up using either the Orbit ACS Menu commands or via the Modbus Interface
