© 2021 AMETEK Power Quality Solutions | Technical Support 800-645-9721 | surgex.com
16
User Manual
SNMP Setup
Item
Description
Enable SNMP
Specifies whether or not to enable the SNMP agent.
Port
Specifies the port number for the SNMP agent. 161 is the standard SNMP port.
SNMP V1 Communities Is a table of all SNMP communities, supporting SNMP V1 at a minimum.
Name
Specifies the Community name for read and/or write access.
Source
Specifies an unrequired whitelist. If requests are not to be filtered by hostname or IP Address, this
field can be left blank.
Access
Specifies the type of access allowed by the community.
SNMP V3 Users
Is a table of Users specifically for SNMP V3 authorization. Users here will not apply to the REST
API, and REST API users will not be able to authenticate via SNMP V3 without redefining their
credentials here. SNMP credentials cannot be authenticated using the LDAP Client.
Name
The name or username for authorization.
Authorization
Type of encryption used per user. Options are DES or MD5.
Access
Type of access per user. Options are Read Only or Read/Write.
Passphrase
Passphrase or password for the user.
Trap Receivers
Is a table of all the destinations for SNMP traps.
Name
The name of the community for traps.
Host Name
The hostname or IP address of the SNMP Manager that is going to receive traps.
Port
The port number that the SNMP Manager is listening for traps on.
Traps Sent
Specifies which specific traps are to be sent. Triggers send traps for Triggering and Clearing.
Manual Control sends traps for outlet state changes, and Authentication sends traps for failed
authentication attempts.
