Amewi 26088, Instruction Manual

12

2. Two left cabin inner cover lock twisted to right and open them. And the right 
    two locks turns to left to open(picture 3), then you can take out the inner cabin
    cover(picture 4).

Picture 5

Picture 6

amewi.com

Picture 3

Picture 4

Lipo battery

5. Connect the Lipo battery socket 
    with ESC power terminal and the
    transmitter will make a sound 
    dididi, it shows code pairing 
    successfully.

4. Power on the transmitter, then the transmitter LED indicator will start to flash,
    and it shows ready to code 
    pairing.

Notice:  1. After power on the boat, the motors will make a sound di... Di....

2. The Lipo battery wires need to put aside of the boat to avoid tangled or broken 
    off by the rudder wheels.
3. If there is a few boats to play together, you need to code pairing one by one, and
    can not do it at the same time to avoid improper opertaion and cause danger.

6. After operate above steps, please install the covers as below order:

①

 Install the inner cover to the hull and then tighten the inner cover lock.

②

  Install the outer cover to the hull and then tighten the outer cover lock.

3. Put the Lipo battery into the boat battery holder(picture 5), then use velcro tape
    to fasten the battery is OK.(Picture 6)

Lipo battery

velcro tape

A B

C

电压检测线 电源/信号线

电源线

Lipo battery