Operation
Linear Lift AL1
Page 29 of 72
Press and hold the “FOLD” push-button (4) on the remote con-
trol.
The linear lift raises the platform further. The platform and the guard-
rails fold up to the vertical, stowed position.
The vertical, driving position has been reached as soon as the linear
lift stops moving. In this position the Lift is not engaged in the arres-
ter hooks.
Release the "FOLD" push-button (4).
NOTE
The Lift is not in the vertical position when it is engaged in the arres-
ter hooks.
The arrester hooks serve only as an emergency measure, to pre-
vent the Lift from falling against the door of the vehicle if there is a
loss of pressure in the hydraulic system (see Section 11.6, page 50).
CAUTION!
There is a risk of crushing when folding the linear lift to the vertical,
stowed position.
Fingers and hands can be crushed between the carrier struts and
the guardrails and between the carrier struts and the platform.
Therefore:
y
Never reach into the area between carrier struts and guardrails
when folding the linear lift up to the vertical, stowed position.
y
Never reach into the area behind the platform when folding the
linear lift up.
Replace the remote control to its holder.
Switch the linear lift OFF at the battery isolation switch (5) (see
Figure 9, page 24).
Close the rear vehicle door.
Summary of Contents for LINEARLIFT AL1
Page 1: ...Operating Instructions www amf bruns de LINEAR LIFT AL1 ...
Page 2: ......
