AMG Systems Ltd. reserves the right to make changes to this
document without notice. The information herein is believed to
be accurate. No responsibility is assumed by AMG for its use.
Page 8 of 8
AMG5918 Instruction Sheet D22155-
00.doc
Alarm Interface Connections
Alarm Interfaces
Connector Pin
No.
Alarm IN
1-4
Alarm OUT
1-4
1
ALARM 1 IN
ALARM 1 OUT
2
ALARM 2 IN
ALARM 2 OUT
3
GND
GND
4
ALARM 3 IN
ALARM 3 OUT
5
ALARM 4 IN
ALARM 4 OUT
Physical Information
Dimensions
Height...................................................112mm
Width....................................................170mm (excluding connectors)
Depth ...................................................35mm
Weight..................................................200grams
Mounting Details
The AMG unit is supplied with a clip-on mounting bracket which should be attached to a panel or wall
using 2 off 4.0mm screws, see diagram on page 1 for dimensions. The unit is clipped into the
mounting bracket, and is then held firmly in position.
Safety
AMG Optical Fibre Products use Class 1 laser systems in accordance with EN 60825-2:2000.
It is always advisable to follow good practice when working with optical fibre systems. This includes:
Do not stare with unprotected eyes or with any unapproved collimating device at fibre
ends or connector faces, or point them at other people.
Use only approved filtered or attenuating viewing aids
For other safety issues and advice on good practice associated with optical fibre systems, please see
EN 60825-2:2000 or your local safety officer.
Maintenance and Repair
There are no user serviceable parts within AMG products. See unit data sheet for full specification.
In case of problem or failure, please call your local support centre or contact:
AMG Systems Ltd.
at
3 The Omega Centre, Stratton Business Park, Biggleswade, Beds., SG18 8QB, UK.
Phone
+44 (0) 1767 600 777
Technical Support
+44 (0) 1767 604 491
techsupport@amgsystems.com
