2.Determine on which side of the unit you want to install the
backrest. Make sure the unit will be facing the faucets with
the armrest on the inside of the bathtub (See Fig. 1)
3.To install the seat and backrest assembly, place the front
seat z-clamps under the front frame support tube. Lower
the seat back and snap the back seat white clips into place.
4.Adjust the unit to the desired height by pressing in the leg
push-button and sliding the leg upward or downward until
the button snaps into desired hole.
NOTE:
The transfer bench should be level. It is therefore possible
that the legs inside the bathtub may be adjusted to a height
different from the legs outside the bathtub.
5.Place the transfer bench with the suction tips legs over the
bathtub wall. The inner legs should be as close to the far
wall of the tub as possible.
6.Push down gently on the transfer bench to securely affix
the suction tip feet to the tub floor.
7.To remove the unit from the bathtub, always release the
suction tips by
first pinching the tabs so as to break the
suction. Failure to do so will make it difficult to lift the
unit.
