AMG Systems Ltd. reserves the right to make changes to this
document without notice. The information herein is believed to
be accurate. No responsibility is assumed by AMG for its use.
Page 4 of 8
AMG4642ER Instruction Sheet
D16980-01.doc
Connections
Video Output Connections
No. of channels....................................4
Connectors ..........................................75 ohm BNC Socket.
Output Impedance ...............................75 ohm terminated.
Output Level ........................................1 Volt p-p nominal
Frequency Response...........................10Hz to 7MHz.
Optical Connections
PRIMARY OPTO OUT
Connector ............................................LC/PC
Primary Optical Launch Power ............-5dBm
Wavelength..........................................1310nm
Optical Fibre ........................................Multimode 50/125 or 62.5/125**
PRIMARY OPTO IN
Connector ............................................LC/PC
Primary Optical Sensitivity...................-22dBm
Wavelength..........................................1310nm
Optical Fibre ........................................Multimode 50/125 or 62.5/125**
**Note: the transmission distance is limited by the bandwidth of the Multimode optical fibre. The optical
data rate is 1.25Gbits/s. The maximum bandwidth specification at this data rate for Multimode fibre is
2km. although in most cases the units will operate successfully over longer fibre lengths. It is
advisable however for distances greater than 2km, to have the optical fibre tested.
Power Connection
Power supply .......................................from plug in connection on the AMG2009 / AMG2015 subrack
Power consumption .............................10 Watts max.
Ethernet Connection
Ethernet Data Connector ....................RJ45
Interface...............................................Auto-negotiation up to 100BASE-TX full duplex
Ethernet Data Rate ..............................Maximum 100Mb/s total Ethernet traffic on fibre
