22022626 Rev A
12
NGX Ultra Jukebox
HDMI
Splitter
Core
Computer
Upper Display
IN
OUT
OUT
To External
Display
Lighting Controller
The NGX ULTRA lighting assembly can be
programmed for several different modes of operation.
By default, the lighting assembly is set to display
random colors and random patterns.
To change the mode, open the main door of the
jukebox. The LED controller is located on the lower
left hand side of the jukebox cabinet. There are two
adjustment pots on the board marked
BRIGHT
and
SPEED
. These are used to set the brightness of the
LEDs and adjust the speed of color changes for the
color cycle display modes.
The five position DIP switch is used to set the
operating mode of the controller. Use the following
table to set the mode.
Beat to the Music
The NGX Ultra includes an audio interface, located
above or on the LED Controller, which allows the
LEDs to change to the beat of the music.
To disable this feature, simply disconnect the audio
cable going to the board.
SW1
SW2 SW3
SW4
SW5
Mode
OFF
OFF
OFF
OFF
ON
Color cycle – quick change between colors
ON
OFF
OFF
OFF
ON
Static – Red
OFF
ON
OFF
OFF
ON
Static – Yellow
ON
ON
OFF
OFF
ON
Static – Green
OFF
OFF
ON
OFF
ON
Static – Cyan
ON
OFF
ON
OFF
ON
Static – Blue
OFF
ON
ON
OFF
ON
Static – Magenta
ON
ON
ON
OFF
ON
Static – White
OFF
OFF
OFF
ON
ON
Static – Orange
ON
OFF
OFF
ON
ON
Static – Rose
OFF
ON
OFF
ON
ON
Color cycle – Rainbow: Pastels
ON
ON
OFF
ON
ON
Color cycle – Patriotic: Red, White and Blue
OFF
OFF
ON
ON
ON
Color cycle – Holiday: Reds and Greens
ON
OFF
ON
ON
ON
Color cycle – programmed colors and patterns
OFF
ON
ON
ON
ON
Color cycle – random colors and patterns (default)
ON
ON
ON
ON
ON
Color cycle – gradual change between colors
---
---
---
---
OFF LED lighting OFF
External Video Display
An external video display can be used with NGX
Ultra. However, an HDMI splitter must be purchased
separately. These are available from just about any
electronics retailer like Best Buy or Amazon.com.
The HDMI splitter should be installed inside the
jukebox. The video source is the Video Card inside
the core computer assembly. Disconnect the HDMI
cable from the core computer video card (yellow
mounting plate) and plug it into the primary HDMI
output on the HDMI splitter. Plug the HDMI splitter
input cable into the HDMI connector on the Video
Card in the core computer (yellow mounting plate).
The HDMI cable going to the external monitor will
plug into one of the other HDMI outputs on the
splitter. Route the HDMI cable out one of the cable
access holes in the bottom of the NGX Ultra cabinet.
If the splitter needs 120 volt power, you may be able
to use the Router plug on the Power Distribution unit
in the NGX Ultra jukebox. Just be aware, that outlet
will be power cycled every 15 to 30 minutes if the
Internet connection to the AMI servers is lost.
Normally this is not a problem.
Summary of Contents for NGX ULTRA
Page 6: ...22022626 Rev A 4 NGX Ultra Jukebox This page is intentionally left blank ...
Page 28: ...22022626 Rev A 26 NGX Ultra Jukebox This page is intentionally left blank ...
Page 40: ...22022626 Rev A 38 NGX Ultra Jukebox This page is intentionally left blank ...
Page 50: ...AMI Entertainment Network LLC 4147 Eastern Avenue SE Grand Rapids Michigan 49508 ...
