NiteHAWK Internet Jukebox
Troubleshooting
22022613 Rev A
7-1
Section: 7 Troubleshooting
Introduction
The NiteHAWK Jukebox incorporates several modules which plug in for rapid service.
The most likely cause of jukebox problems is:
1. Continuous or intermittent open circuits in a harness. The cause can be broken or
cut wires, a damaged terminal, or a bad terminal crimp.
•
Check that all plugs are firmly seated.
•
Check that connector pins are not bent, broken, or pushed through the back
of connectors when mated.
2. A defective module. Troubleshooting procedures are directed at module
replacement, not repair.
A summary of the functions for each of the jukebox’s replaceable modules is in
Major
Components of the NiteHAWK
in Section 1.
The troubleshooting topics presented in this section are:
•
The NiteHAWK indicator LEDs can help you isolate a problem.
•
A sequence of operation explanation in this section and a wiring
diagram (Figure
7–1
)
help you isolate the problem to a harness or a module. The wiring diagram
also shows the part numbers of the harnesses and modules.
•
Modular Troubleshooting Charts that list the Trouble, Symptom, and Probable
Cause.
Summary of Contents for NiteHAWK
