18
TROUBLESHOOTING
Appliance error codes
The tumble drier indicates error codes to help locate minor operating faults and identify their
cause. The ERROR CODES help locate and determine the cause.
Detected errors are indicated as shown in the following table:
When an error occurs, the appliance beeps (if active).
If you cannot deal with the fault by yourself and need help:
1.Press the [On/Off] button.
2.Pull out the mains plug and call the service.
Problem
Solution
l
Display does not come on
l
The mains plug is inserted.
l
Check the programme selected.
l
Check fuse in the house.
is flashing
l
Empty condensation container.
l
If failure, check hose for
condensation outlet.
is flashing
l
Clean air cooler.
l
Clear lint filter.
l
Dryer does not start
l
Check the start button has selected.
l
Check the door has closed.
l
Check the programme has set.
l
Water is running out
l
Align dryer horizontally.
l
Clear air condenser and door seals.
l
Door is open by itself
l
Press door until it “clicks”into position.
l
Check the clothes is over load.
l
Humidity in the room is increase
significantly
l
Ventilate room adequately.
l
Clean the cool grille.
l
Ensure that the air condenser has
been inserted.
l
Degree of dryness was not reached
or drying time too long
l
Clean lint filter and wash condenser.
l
Empty container.
l
Check water outlet.
l
Dryer installation too restricted.
l
Clean the moisture sensors.
l
Use next higher drying programme
or using
l
Timer programme.
