33
1. Operational safety.
All safety instructions included in chapter IV must be observed. Textile grease filters and carbon filters
should be replaced and aluminium filter should be cleaned according to manufacturer’s instructions, or
more frequently in periods of intensive use (more than 4 hours a day). If a gas cooker is used it is for
bidden to leave uncovered flame. When removing pots from gas burners set the flame to its minimum
level. Always make sure that flame does not extend outside the pot. Such a situation causes undesired
energy losses and dangerous heat buildups. The hood should not be used for other purposes than
those for which it was designed.
VI OPERATION AND MAINTENANCE
EN
2. Operation:
2.1 Control panel
The cook hood fan can operate at 5 speeds. Select the fan speed appropriate for cooking intensity. To
run the fan press the „ ” button on the control panel (Figure 1, item 3). Touch the „
>
”. sensor each
time you want to increase the fan speed or touch the ” ” sensor to reduce the fan speed. When
you turn on the cooker hood the fan always runs at speed 2. Touch the ” ”, sensor to activate the
countdown timer. Touch the „ „ sensor to activate the timer. The appliance will turn off after 15 minutes.
When the timer is counting down the digit will blink on the display and the appliance will turn off after
15 minutes.
To remove any residual odours and vapour from the kitchen it is recommended to use the hood for
several minutes after cooking.
Lighting
Your cooker hood features LED lighting. Touching the ”
” sensor on the control panel (Figure 1,
item 3) to turn on or off the lighting.
Remote control (Fig. 19)
Your cooker hood can be controlled by a remote control.
Remote control functions are described below:
A. Turn the fan on/off
B. Increase the fan speed
C. Reduce the fan speed
D. Turn the lights on/off
Touch the POWER sensor to turn on the appliance. The fan will run at speed 2.
Hood lighting can be switched on independently of the „POWER” sensor.
To use the remote control:
Gently bend the tab and pull out the battery compartment cover.
Place the new batteries in the remote control according to the markings inside battery compartment.
Close the battery cover.
Point the remote control toward the front of the cooker hood.
Ensure there are no obstacle between the remote control transmitter and the sensor on
the cooker hood.
Fluorescent light can interfere with the remote control operation.
