Amica OSS 522, Manual

     33

V INSTALLATION

Connecting to the power network and operation check

After connecting the device to the power supply network (in accordance with the requirements defined 

above) it is necessary to check operation of the motor and lighting of the hood.

Setting the operation mode of the kitchen extractor hood
Setting the air extractor mode of operation of the hood

When cooker hood operates in extraction mode, air is discharged outside through an extraction duct. 

The cooker hood is connected to the air outlet opening using a rigid or flexible extraction duct with 

a diameter of 120 mm, and the appropriate clamps, which must be purchased at a hardware store. 

Connect one end of the duct to the flange (Fig. 17), and the other to the air outlet hole. Proper duct 

routing is shown in Fig. 18 Also, make sure that one of the inserts is installed (install a bigger one for 

the extraction mode (Fig. 9)). To install or remove the insert, undo the screw and slide the insert along 

the rails (Fig. 4b).

A qualified installer should be commissioned to make the connection.

Setting the odour absorber mode of operation of the hood

In this setting the air is filtered and returned back to the room through openings located in the upper part of the body 

of the hood. Install activated charcoal filter in this setting (see the manual for details on installation). Also, make sure 

that one of the inserts is installed (install a smaller one for the extraction mode (Fig. 8)). To install or remove the 

insert, undo the screw and slide the insert along the rails (Fig. 41). In addition, air outlet hole should be plugged (Fig. 

4c).

Fan speeds

The lowest and medium speeds should be used under normal conditions and with low concentration of 

fumes. The top speed should be used in case of high concentration of kitchen fumes, e.g. during frying 

or grilling.

EN

Install the cooker hood under a wall cabinet:

1.  Drill 4 holes in the wall cabinet that match the spacing of holes in the hood.

2.  Make a hole (over 120 mm in diameter) to fit the extraction duct or the plug. The hole must be located directly 

above the cooker hood air outlet.

2.  Using the supplied four mounting screws (M4X30) attach the hood to the wall cabinet (Fig. 15).

3.  Depending on the mode of operation (extraction or odour absorber - for see details see the manual) fit the plug 

(Fig. 10 and 16) or the exhaust duct flange (Fig. 11 and 17).

4.  Connect the hood to power and make sure it operates correctly.

Install the cooker hood on the wall:

1.  Drill 2 holes in the wall that match the spacing of holes in the hood (Fig. 12). Put plastic wall plugs in the holes 

(Fig. 13) and screw in hooks (Fig. 14).

2.  Hang the hood on the wall, connect it to power and make sure it operates correctly.