www.amico.com 13
Section 3: Installation to Monitor and Accessory
Monitor Shelf: 3" (76.2 mm) Top/Back Mount, 5" (127 mm) Top/ Back Mount and VESA
WARNING:
ENSURE THE MOUNTING SHELF IS SECURELY LOCKED AND HORIZONTAL TO PREVENT THE MONITOR
FROM SLIDING AND FALLING.
WARNING:
ON THE BOTTOM OF THE MOUNTING SHELF THERE IS A PLUNGER THAT SECURES THE SHELF TO THE
MOUNTING ADAPTER. SIMPLY PULL DOWN ON THE PLUNGER, ALIGN THE ADAPTER PLATE WITH THE SHELF AND
RELEASE THE PLUNGER ONCE POSITIONED OVER THE CLEARANCE HOLE
(FIGURE 3)
.
NOTE:
The plunger can be locked in the open position by pulling and twisting it.
1. First install the mounting adapter to the device (Please refer to the adapter installation manual provided with the
adapter)
(Figure 1)
.
2. Loosen the plastic screws on the bottom side of the mounting shelf. Pull down on the plunger lock at the bottom of
the mounting shelf and twist it to keep it open. Slide the adapter laterally onto the mounting shelf until the plunger
aligns with the clearance hole at the front of the mounting adapter
(Figure 3)
.
3. Release the plunger and tighten the plastic screws by hand
(Figure 4)
.
Mounting shelf
Monitor
Mounting
adapter
Front of the
mounting
adapter
Monitor
dependant
hardware
Figure 1
Figure 2
Mounting shelf
Front of
the shelf
Plunger Lock
5" (127 mm) mounting shelf is shown above
Plastic
Screws
Plunger released
Plunger pulled
Figure 3
Figure 4
